Ever jumped into a photo booth on a night out, squashed up with your friends and walked out flash-blind while holding a wet strip?
Your four blurry photo strips and spontaneous face poses deserve to be immortalised on a deserving ceramic frame.
Variations:
Oil Spill: grey-purple and black glaze, with deep green leaks. The developer fluid you should not be sniffing.
Pink Noise: dusty pink and lilac patches breaking through a black glaze. The phantom spots you see when you blink.
Size and fit:
These frames are designed to fit a Vintage European analog 4-pose photo strip.
*Photo booth strip sizes may vary from machine to machine. Do note that trimming may be required to fit if your photo is too big.
Frame dimensions: Approx 24cmL x 10.5cmW x 1.5cmH
Fits photo strip dimensions:
Width: 3.5cm to 4cm
Height: 20cm to 24cm
How it works:
3 turn-button fasteners on the back hold your photo in the inset area.
A removable hardboard backing is included.
To hang it, use the sawtooth hanger on the back. The frame hangs in portrait orientation.
Adjusting the fasteners:
Loosen or tighten the turn buttons with a screwdriver. If it gets too tight, adjust with a tool or the closed tip of a pair of scissors to keep your fingers safe
Important Note:
Glaze colours and patterns vary from piece to piece, so yours may differ from the photos shown.
As these are delicate hand-built wares that may experience mild warping, trimming of your photos may be required, especially if your photo strips are larger than the above stated dimensions.
Ever jumped into a photo booth on a night out, squashed up with your friends and walked out flash-blind while holding a wet strip?
Your four blurry photo strips and spontaneous face poses deserve to be immortalised on a deserving ceramic frame.
Variations:
Oil Spill: grey-purple and black glaze, with deep green leaks. The developer fluid you should not be sniffing.
Pink Noise: dusty pink and lilac patches breaking through a black glaze. The phantom spots you see when you blink.
Size and fit:
These frames are designed to fit a Vintage European analog 4-pose photo strip.
*Photo booth strip sizes may vary from machine to machine. Do note that trimming may be required to fit if your photo is too big.
Frame dimensions: Approx 24cmL x 10.5cmW x 1.5cmH
Fits photo strip dimensions:
Width: 3.5cm to 4cm
Height: 20cm to 24cm
How it works:
3 turn-button fasteners on the back hold your photo in the inset area.
A removable hardboard backing is included.
To hang it, use the sawtooth hanger on the back. The frame hangs in portrait orientation.
Adjusting the fasteners:
Loosen or tighten the turn buttons with a screwdriver. If it gets too tight, adjust with a tool or the closed tip of a pair of scissors to keep your fingers safe
Important Note:
Glaze colours and patterns vary from piece to piece, so yours may differ from the photos shown.
As these are delicate hand-built wares that may experience mild warping, trimming of your photos may be required, especially if your photo strips are larger than the above stated dimensions.